Tru Mark had the opportunity to repair a Wind Weight Tarp, 26 foot diameter (TAF 3426), for the home plate area. Several holes were discovered during the inspection.
A local tarp and awning company, was consulted on the proper material and procedures to be used. He asked that a sample of the material be provided so he could match the patch material and the correct adhesive cement.
The following is the list of material and process used to repair a Wind Weight Tarp. A photo album is available for tarp repair items used and application process.
Supplies include:
- tarp patch material as the same as the tarp,
- adhesive cement to match with tarp material,
- scissors for trimming the patch material,
- roller for creating a uniform pressure across the patch,
- flat solid surface, and
- cleaning material to include towel(s) and cleaning solution such as Simple Green.
Procedures followed to complete the tarp repair:
- access the bottom of the tarp surface,
- identify and clean the surface of the tarp with water (and cleaning solution),
- create patch (rounded edges),ensure plenty of overlap to the damaged area,
- apply adhesive cement to both the tarp and patch(rough side if available),
- apply patch and then compress from center to outside edge using a roller if possible, ensure you have the solid flat surface under the tarp so the patch is applied evenly,
- let adhesive cure for 15 to 30 minutes,
- check workmanship.
Do not limit the amount of adhesive applied to both the tarp and patch. The rolling device will remove excess adhensive when pressure is applied from the center to the edge to the patch.